University of Pittsburgh at Bradford Shines Bright: Innovative Inverter Solution Solves Design Challenges for 108kW Solar Installation
The bifacial rooftop array on the University of Pittsburgh’s Pitt-Bradford campus is expected to offset 40% of the building’s total electricity use, powering high energy loads such as a virtual reality lab, computing, engineering and energy studies.(Image)
- Pitt-Bradford rooftop solar installation forecast to produce 116,500 kWh of electricity each year, offsetting approximately 40% of the building’s electricity use
- DC-optimized solution provides flexibility to position modules in multiple directions and unequal string lengths – key to meeting the building’s high energy requirements.
3rd August 2023 – The University of Pittsburgh is celebrating the installation of the first of several SolarEdge DC-optimized rooftop solar installations across multiple campuses. The 108kW system is installed on the state-of-the-art George B. Duke Engineering and Information Technologies Building on the Pitt-Bradford campus in Bradford, Pennsylvania. Now operational, it is expected to produce 116,500 kWh of electricity each year, offsetting approximately 40% of the building’s total electricity use.
The rooftop solar installation is a key part of the University’s goal to achieve Leadership in Energy and Environmental Design (LEED) certification for the Pitt-Bradford building, which serves as the campus hub for engineering, computing, and energy studies. It will help to power the facility’s virtual reality lab, networking lab, makerspace, ample fabrication space, and engineering shops, all of which provide students with invaluable hands-on learning opportunities.
The solar system was designed and installed by Pittsburgh-based installer, EIS Solar. It chose SolarEdge’s DC-optimized inverter solution to overcome design challenges that would have otherwise significantly reduced the amount of energy the system could produce.
“While the new Pitt-Bradford building is remarkable, the solar installation component was technically very challenging,” comments Joe Morinville, President, EIS Solar. “The roof accommodates a large mechanical penthouse, which meant we were only able to install panels on about one-third of the roof. Another challenge was the nine feet tall skirting around the penthouse which will cast shading over portions of the solar array at certain times of the day. Given these constraints, it would not have been possible to generate enough power from the roof with a traditional string inverter system to make solar a viable investment for the University. However, with SolarEdge’s DC-optimized technology we have been able to realize Pitt’s vision of powering its curriculum with clean, renewable energy.”
The Pitt-Bradford system is comprised of 200 bifacial modules which are installed in two separate arrays on either side of the penthouse. Each array is controlled by a SolarEdge inverter and uses SolarEdge Power Optimizers attached to each pair of modules to enable them to operate independently from others on the same string. This provided EIS Solar with the flexibility to position the modules in an east-west configuration and in uneven string lengths – crucial to maximize the number of modules that could be fitted onto the roof. The Power
Optimizers bring additional production gains by mitigating power losses caused by module degradation and mismatch. The latter is especially common in bifacial modules due to the reduced surface albedo and irradiance differences on the rear side of the modules caused by their close proximity to the roof.
“We have been operational in Pittsburgh for 14 years and from day one SolarEdge has been our go-to inverter solution,” says Morinville. “For high-energy consumers such as Pitt-Bradford, every watt of power counts. SolarEdge’s DC-optimized inverter solution enables us to overcome design challenges and optimize module performance to generate maximum energy output. It is a game-changer for the solar industry and a testament to our commitment to delivering the best possible solar solutions to our customers.”
“Pitt-Bradford is proud to boast the largest rooftop array across five University of Pittsburgh campuses to date,” comments Dr. Matt Kropf, Director of the Energy Institute at Pitt-Bradford. “This new solar installation joins one on the Richard E. and Ruth McDowell Sport and Fitness Center in helping Pitt-Bradford students experience the importance of solar first-hand in our growing energy and science curricula and our region.”
The University’s Executive Director of Sustainability, Dr. Aurora Sharrard, adds: “As we advance toward our goal of producing or procuring 100% renewable electricity by 2037 across the University of Pittsburgh, Pitt-Bradford has been a leader in advancing rooftop solar on Pitt buildings.”
SolarEdge is a global leader in smart energy technology. By leveraging world-class engineering capabilities and with a relentless focus on innovation, SolarEdge creates smart energy solutions that power our lives and drive future progress. SolarEdge developed an intelligent inverter solution that changed the way power is harvested and managed in photovoltaic (PV) systems. The SolarEdge DC-optimized inverter seeks to maximize power generation while lowering the cost of energy produced by the PV system. Continuing to advance smart energy, SolarEdge addresses a broad range of energy market segments through its PV, storage, EV charging, batteries, electric vehicle powertrains, and grid services solutions.
SolarEdge is online at https://www.solaredge.com