/ News / Premium Cortec M-540 Additive Enables Bio-Based and Ester-Based Greases to Pass Rust Prevention Test in 5% Seawater

Premium Cortec M-540 Additive Enables Bio-Based and Ester-Based Greases to Pass Rust Prevention Test in 5% Seawater

Parul Dubey on May 4, 2018 - in News, Products

A good corrosion inhibiting additive can fundamentally boost the performance of grease used in equipment exposed to harsh conditions of humidity and salt spray. While greases themselves provide a measure of corrosion protection, bearings and gears are more vulnerable to corrosion during periods of inactivity when the grease is not circulating. At this time, water condensation and puddling can silently initiate a corrosion site that may cause failure when the operator comes to restart equipment. The situation worsens if bearings fail on operational spares needed at a moment’s notice. Protecting against corrosion provides insurance against the headaches and costs of rusted gears, bearings, and housings that must be repaired or replaced before equipment can be used again.

 

Developing an exceptional corrosion inhibiting grease for use even in harsh salt spray conditions is possible with Cortec’s new M-540 premium quality additive. M-540 is formulated with proprietary technology to provide superior corrosion protection in bio-based and ester-based greases. It provides excellent long-term protection, even in humid and salt-containing environments, such as coastal and offshore conditions, where the chance for condensation and corrosion increases. When tested according to ASTM D5969 for rust prevention, grease that failed to prevent rust in a 5% seawater solution was able to pass the same test after M-540 was added. This seawater performance makes M-540 an ideal additive for formulating greases used in marine conditions such as those on offshore rigs.

Another important advantage of M-540 is that it not only provides corrosion protection to metals in direct contact with the grease; it also provides corrosion protection to nearby metals in bearing housings not directly touching the grease. Normally, to provide full protection to the cavity surrounding a gear or bearing, the space must be completely flooded with lubricant to allow the maximum level of surface contact possible with the corrosion inhibitor and minimize oxygen in the headspace. In contrast, M-540 contains Vapor phase Corrosion Inhibitors that vaporize and diffuse throughout the void space. These molecules form a protective layer on metals above the surface of the grease as well as those in direct contact with it. Only a standard amount of grease containing M-540 will be required for layup or intermittent use of equipment, yet void spaces where moisture might condense will also be protected.

 

M-540 is an excellent choice for formulators who want to enhance the corrosion inhibiting power of their grease. M-540 is easily dilutable with a variety of bio-based or ester-based greases and is compatible with copper. Dosage rates range from 2-10% depending on the level of corrosion protection desired. M-540 does not reduce the dropping point of the grease to which it is added.

 

To find out more about M-540, please visit: https://www.cortecvci.com/Publications/PDS/M-540.pdf

 

Cortec® Corporation is the global leader in innovative, environmentally responsible VpCI® and MCI® corrosion control technologies for Packaging, Metalworking, Construction, Electronics, Water Treatment, Oil & Gas, and other industries.  Our relentless dedication to sustainability, quality, service, and support is unmatched in the industry. Headquartered in St. Paul, Minnesota, Cortec® manufactures over 400 products distributed worldwide.  ISO 9001, ISO 14001:2004, & ISO 17025 Certified. Cortec Website: http://www.cortecvci.com Phone: 1-800-426-7832   FAX: (651) 429-1122

Comments are disabled